2L-6714-00

FOLD AND ROLL PLAYBACK

TABLE TENNIS TABLE

OWNER'S MANUAL

MODEL NOs.

T8108

WARRANTY

Actual product may

differ slightly from that

shown in illustrations.

READ ASSEMBLY &

OPERATING INSTRUCTIONS

AND ALL SAFETY

INFORMATION CAREFULLY!

2L-6714-00

Manufactured under one or more of the following patents:

6,345,820 6,196,953 6,179,733 6,120,397 6,117,051 5,921,227 5,919,102 5,901,692 5,899,824 5,816,957 5,769,744 5,749,351 5,718,212 5,672,144 5,498,004 5,392,757

5,318,489 5,271,625 5,213,554 5,169,360 5,158,512 5,119,741 5,071,120 5,067,728 4,911,085 4,798,381 4,717,157 4,596,228 4,546,754 4,519,374 4,515,142 4,424,968

D442,654 D425,943 D425,572 D420,563 D330,234 D330,057

CAUTION

THIS IS A GAME TABLE. DO NOT SIT, STAND, LEAN, WALK OR JUMP ON TABLE! FAILURE TO COMPLY

WITH THIS CAUTION COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE!

This table must be kept indoors to prevent damage to the playing surface. Dampness and extreme

temperature changes which occur on patios, garages or similar areas can cause wood to warp, swell,

crack, or blister.

UNLEVEL FLOORS

If table does not seem level, it is probably because floor is not level. Move table several inches (set table

in playing position) in different directions to find the best location for the table. If the floor is extremely

unlevel, table may not play or operate properly. If table is high in the center, shim up under the outer

legs.

Questions, Concerns, Comments?

Need to Purchase Replacement Parts?

Need Product Assistance?

Escalade Sports, a diversified manufacturer of fine sporting goods equipment, is here to help you in any way

possible to make your experience with this product a pleasurable one for you and your family. We always try

hard to make sure that our products are manufactured free from defects in material and workmanship to

provide a lifetime of family fun. If you find any problems with your new product such as missing parts,

damaged parts, or incorrectly manufactured parts,

Please Do Not Return This Product to the Store!

Please contact our consumer affairs department at:

Phone 1-866-873-3528 Toll – Free !

Fax 1-866-873-3533 Toll – Free !

E-mail [email protected]

Additionally, we highly recommend that you visit our web site for additional

information or possible solutions for your concern which include:

On-Line Trouble Shooting *** On-Line Parts

Requests *** Technical Assistance *** Frequently

Asked Questions *** Additional Escalade

Product Information

Mailing Address: Escalade Sports

PO Box 889

Evansville, IN 47706

CARE AND MAINTENANCE

You have purchased a quality product that will give you years of enjoyment. By following these simple maintenance steps you

will add to the life of your new table. The top (playing surface) of your table is of a particle board construction. Like all products

made of wood, it can be affected by atmospheric conditions, meaning both temperature and humidity. This may cause a slight

sag or distortion as top expands or contracts. This is normal and should not cause concern as it does not detract from the play

or utility value of the table. To help minimize this problem, store table in folded up position in a dry area when not in use.

STORAGE OF YOUR TABLE

This table must be stored indoors to prevent damage to the playing surface. Dampness and extreme temperature changes

which occur on patios, garages or similar areas can cause the wood to warp, swell, crack, or blister. When your table is not

in use, it should be folded up in a dry area.

CLEANING YOUR TABLE

To clean your table use a soft damp NOT WET cloth only. To prevent damage to your table's playing surface DO NOT use

any chemicals, abrasive, or cleaning products on your table's playing surface.

IMPORTANT: Periodically, lubricate all moving parts, including pivot points, to assure smooth opening and closing. A light

lubricant such as WD-40 is recommended.

LIMITED 1 YEAR WARRANTY

Manufacturer warrants to the original retail purchaser, this product to be free from defects in material and

workmanship for a period of ninety (90) days from the date of purchase.

Should this product become defective due to material or workmanship within the warranty period, contact our

Customer Service Department for repair or replacement at our option.

This warranty is not transferable and does not cover normal wear and tear, bowing of the table or damage caused

by improper handling, installation or use of this product. This warranty is also void if product is in any way abused,

damaged, or modified from its original state, or if used for other than residential use.

This warranty gives you specific legal rights, and you may have other rights which vary from state to state.

READ AND FOLLOW ALL ASSEMBLY, OPERATING, AND

SAFETY INSTRUCTIONS CAREFULLY. AT LEAST TWO (2)

ADULTS ARE NEEDED TO PUT THIS TABLE TOGETHER!

1. Attach wood bottom board (#2) to caster rails

(#1) as shown in Figure 1. Turn caster rail as

shown with pivot tubes toward inside, and attach

tube (#2) with four carriage bolts (#3) and four

wing nuts (#4). Tighten wing nuts securely.

Figure 2

Figure 1

PIVOT TUBES MUST

FACE INWARD AND

POINT STRAIGHT UP AS

SHOWN!

AT LEAST TWO (2) ADULTS ARE NEEDED TO

COMPLETE THE REST OF THIS ASSEMBLY! WHEN

ASSEMBLING TOPS TO BASE, HANDLE TOP

ASSEMBLIES BY GRASPING ONLY THE TOPS

THEMSELVES. DO NOT GRASP METAL LEGS, U-

SUPPORT, LINKAGE, OR HINGES. THESE PARTS

CAN MOVE AND COULD PINCH FINGERS OR HANDS

CAUSING SERIOUS INJURY! ASSEMBLE AS

SHOWN WITH LEGS FULLY CLOSED AND TOPS IN

A VERTICAL POSITION. DO NOT OPEN LEGS AND

TRY TO ASSEMBLE. TABLE TOPS ARE HEAVY - DO

NOT ATTEMPT TO ASSEMBLE ALONE!

2. Attach table top (#5) to table base that you just

assembled, as shown in Figure 2. With at least

one adult on each side of table top (#5), lift top and

align ends of "U"-support tube with top of pivot tubes

on caster rails (#1). Slide tubes together.

DO NOT OPEN THE TABLE TO PLAYING POSITION

UNTIL BOTH TOPS ARE INSTALLED! DO NOT LEAVE

TABLE STANDING UNATTENDED. IT COULD BE

KNOCKED OVER CAUSING SERIOUS BODILY

INJURY OR PROPERTY DAMAGE.

3. With two adults, put other table top onto other

pivot tubes following instructions in step 2.

4. Attach corner protectors (#32) to rails using tree

plugs (#22). Simply push the plugs through the

protector and into the rail until snug.

NET ASSEMBLY

Net System Description 1. Net Post Assembly

Attach plastic net post as shown with washer and knob. Note:

there is a left and right net post assembly (See Net System

Description). Post assembly should rest flat against nut plate.

Slide the net sleeve over the vertical post while the net post

assembly is folded in toward the side of the table top. Fold the

net post assembly out against the net post stop into the post

and secure bead chain in catch.

2. Adjustments

A - Adjust overall net tension by slightly loosening the knob and

moving net post assembly. Moderately tighten knob. Net post

assembly should be kept square with the table by the net post

stop (See Net System Description).

B - Adjust tension of cord with bead chain on each side. Assure

that chain is fully seated in catch.

C - Position top of net to a regulation height of 6”

from the table surface by firmly gripping the vertical net post

within height adjustment slot.

3. Storage

Caution: To prevent damage to the net system and/or table

top, the post assembly must be pivoted toward side of table

before lifting table tops to storage position.

Loosen knob and pivot net post toward table side as far as it

will go. Retighten Knob.

OPENING AND CLOSING INSTRUCTIONS

EXERCISE CAUTION IN OPENING/CLOSING TABLE. SMALL CHILDREN, OR CHILDREN NOT

PROPERLY INSTRUCTED IN ITS USE, MUST NOT BE ALLOWED TO OPEN/CLOSE TABLE.

IMPROPER HANDLING AND MISUSE CAN RESULT IN SERIOUS INJURY OR DAMAGE. DO NOT

CLIMB, STAND, OR JUMP ON TABLE. MOISTURE AND CONDENSATION WILL DAMAGE PLAYING

SURFACE OF THIS TABLE. STORE IN DRY, INDOOR PLACE.

CAUTION:

TO OPEN:

1. Hold center of top edge of table top with both hands. Gently pull

outward to midway position. Continue to pull until disengaged from

safety clips and legs rest on the floor. Do not leave table partially

opened at midway position. See Figure 3.

Figure 4

2. Open other table half as in step 1 and 2.

3. Lock all four center hinges. See Figure 4.

Figure 3

Figure 5

TO CLOSE:

Caution: To prevent damage to the

net system and/or table top, the

post assembly must be pivoted

toward side of table before

lifting table tops to storage

position.

1. Unlock all four hinges.

2. Lift table half to midpoint until the

safety clips are engaged. Then

continue lifting until closed.

3. Raise other table half in the same

manner.

PLAYBACK POSITION

CAUTION! Do NOT touch any parts on bottom of

table while opening and closing.

16 2S-6387-02 U Clip 4

17 3M-6248-00 2" Tube end cap 4

18 8S-6415-02 U Support 2

19 4A-6127-00 Half Top 2

20 2S-6143-04 End Rail 2

21 2S-6445-00 Side Rail 4

22 3M-6397-00 Tree Plugs 8

23 3M-6495-00 Paddle/Ball Pouch 1

24 1A-6245-02 Leg Assembly 2

25 8S-6416-02 Linkage Tube 4

26 501-24 1/4" Pal Nut 12

27 3B-6026-00 1/4" x 2 7/8 Rivet 4

28 3B-6007-00 1/4" X 2 3/8 Rivet 4

29 3M-6274-00 Tube Plug 4

30 5A-6781-01 Net & Post Kit 1

31 2S-6139-01 Mounting Bracket 4

32 3M-6393-00 Corner Protector 4

1 4A-6337-11 Caster Rail Assembly 2

8S-6417-11 Caster Rail only 2

2 2W-6268-02 Bottom Board 1

3 1B-6459-00 1/4-20 x 3-1/4" Carriage Bolt 4

4 2B-6082-00 1/4-20 Wing Nut 4

5 2Q-6094-00 3" Caster 4

6 601-84 3/8 Palnut 4

7 2S-6278-10 RH Pivot Bracket 2

8 8S-6418-11 Pivot Tube 4

9 2S-6279-11 LH Pivot Bracket 2

10 701-105 #8 x 9/16 SMS 129

11 3M-6273-00 Plastic Clip 4

12 4A-6336-00 Hinge / Bracket Assembly 4

13 3B-6012-00 1/4 x 2 1/16 Rivet 4

14 2B-6087-00 Nylon Washer 16

15 1A-6285-00 Nut Plate 2

Key# Part# Description Qty.

Replacement Parts List T8108

2L-6714-00

Key# Part# Description Qty.