CDOIF
Chemical and Downstream Oil
Industry Forum
CDOIF is a collaborative venture formed to agree strategic areas for
joint industry / trade union / regulator action aimed at delivering
health, safety and environmental improvements with cross-sector
benefits.
Guideline – Terminal Loading Operations Hazard Awareness v2 Page 9 of 16
3.2.3 Dealing with a Hazard
Training should provide the necessary information for drivers, staff and contractors at a
distribution terminal should overfill occur during a filling operation. Unsafe acts may be
due to safety culture issues with those involved in loading activities, rather than
deficiencies in training programmes. Good communication and understanding between
all parties involved in loading operations should be promoted at all levels. Key
messages should include:
• Promoting a ‘no blame culture’ for initiation of ESD. If there are doubts
concerning the equipment or the loading activity the first action should always be
initiate the ESD.
o If loading has not stopped automatically by the preset volume being
reached, or via the earth/overfill protection system, the most appropriate
action to take is to initiate the ESD.
o Initiation of the ESD at the first signs that the loading process has not
stopped automatically may ensure that overfill is averted, or at least
minimised.
• The overriding principle in the event of an overfill is that personnel should leave
the risk area, and not return until it is safe to do so. Any necessary emergency
response should be by suitably trained and equipped teams. In addition:
o It is important that all personnel on site are aware that an overfill has
occurred so that the emergency plan can be safely activated.
o Because gasoline presents particular hazards (such as those arising from
large vapour clouds) it is essential that all loading gantries are evacuated
until such time that the risk can be properly assessed. Attempting to start
a vehicle on the loading gantry will provide an ignition source.
• Informing all those involved in loading activities that there is no expectation that
the driver is to attempt to stop flow other than to initiate an ESD and inform the
distribution terminal control room.
o Informing the control room ensures that the correct personnel can be
informed and initiate an appropriate action plan
o Where it is safe to do so, the driver should consider closing the vehicle
foot valves. Precise action will be dependent on the vehicle fittings and
any specific site circumstances and loading processes
• ESD initiations will be investigated with a view to identifying ways for improving
the system. These could include redesigning of arrangements to reduce
inadvertent operation, improving procedures for loading and identifying where
better training may be needed. Note that trend analysis of ESD initiations may
reveal key leanings that could be shared externally through trade association
initiatives.